RCScrapyard ► Radio Controlled Model Model Gunboats:
RCScrapyard Radio Controlled Models

RC Ships


Radio Controlled Models Parts and Spares
RC Boats


Radio Transmitters etc Radio Receivers Servos RC Model Boat/Ship Drive Shafts RC Model Boat/Ship Fenders Model Boat/Ship Plans RC Model Boat/Ship Propellers RC Boat/Ship Rudders Smoke Generators Brushless Motors Electronic Speed Controllers Battery Packs Battery Chargers Battery Connectors Fireproof-Bag Bearings and Bearing Sets Glow-Starter-Batteries Gas/Nitro Engines

Items For Sale:


Hints and Tips

Radio Gear

How to avoid Interference.

1/  The first consideration when installing your Receiver into your Electrically Powered Model is to make sure it is well away from the Negative Battery terminal and the Motor. The Magnetic field can cause stuttering type interference at times of high current draw (i.e., Fast Acceleration)

2/  Make sure the Ariel tube is long enough for the Ariel wire. The tip of this wire is highly sensitive and should be as high and as far away from the Motor as possible (yup, its that magnetic field prob again)

3/  If all else fails, a simple tip that often works for all RC Model enthusiasts is to wrap the receiver in Aluminium Foil, to shield against any magnetic and external radio interference.

4/  As a last resort, to protect against servo twitch, try ferrite beads. (available at Radio Shack or Maplins) These are threaded over the red, white (or yellow) and black wires of each servo.

5/  If you are using a FET Servo, the installation of a choke (a small electrical component) in the positive feed wire will smooth out any current spikes and reduce the possibility of "servo twitch".

6/  Another thing you might try is a "glitch buster" or "stutter stopper". Basically, this is a capacitor that simply plugs into your Radio Receiver and attempts to keep a level voltage supply to the Radio system.

For More Setup Information check out my Hints and Tips page.

^ TOP ^

^ TOP ^

^ TOP ^

On/Off Road
RC Models: